Nouveau : Traduire du texte avec ChatDico – 172 langues

Dictionnaire français - anglais

pression de coupe principale

cutting pressure

métallurgie et sidérurgie - iate.europa.eu

▷

Modeling and experimental investigation on ultrasonic-vibration- assisted grinding... Compared to ultrasonic machining, UVAG has much higher material removal rate while maintaining lower cutting pressure and torque, reduced edge chipping and surface damage, improved accuracy, and lower tool wear rate....

métallurgie et sidérurgie - core.ac.uk - PDF: krex.k-state.edu

cutting force

métallurgie et sidérurgie - iate.europa.eu

▷

Laser assisted machining of difficult to cut materials: research opportunities and future directions - a comprehensive review ... The machinability characteristics such as higher cutting force, higher cutting temperature, poor surface integrity and shorter tool life associated with these materials posing many challenges to the researchers, and hence considered...

métallurgie et sidérurgie - core.ac.uk -

Publications scientifiques

▷

Analyze tool wear of cemented tungsten carbide end mill 2t, 3t, 4t for output of force and temperature data using third wave advantedge software simulation... Variations of cutting tool of 2 flute and 3 flute End Mill Cemented Tungsten Carbide Material with serial type of YT15(P10) by diameter 6mm, 8mm, 10mm, respectively are tested using FEM method using simulation of Finite Element Analysis Software which is Third Wave AdvantEdge to predict the cutting force, temperature tested on Stainless Steel AISI 1045....

industries charbonnière et minière / métallurgie et sidérurgie - core.ac.uk - PDF: eprints.ums.ac.id

▷

Nc lathe cutting force measurement method and application of online... Cutting force measurement system by force measurement instrument, general data collection system and PC of three parts....

général - core.ac.uk - PDF: www.scientific.net

▷

Simulation and experimental research on cutting force of turning titanium alloy... The cutting force of the simulation model was verified by the turning experiment, and the relationships of cutting force with cutting speed, feed rate and rake angle of cutting edge...

général - core.ac.uk - PDF: doaj.org

▷

Hard turning of hot work steel aisi h11: evaluation of cutting pressures, resulting force and temperaturepressure, MPa; Kr – radial cutting pressure, MPa; Kv- tan-gential cutting pressure, MPa; R - coefficient of determi-nation; VB- flank wear, mm; vc- cutting speed, m/min; α-relief angle, degree; γ-rake angle,...

général - core.ac.uk - PDF: www.ktu.lt

▷

Experimental investigation on cutting forces, specific cutting pressure, co-efficient of friction and shear energy in turning of hsla steel... The effects of machining parameters on cutting force components, Specific Cutting Pressure (SCP), co-efficient of friction and shear energy are analysed during the investigation....

général - core.ac.uk - PDF: doaj.org