Traductions en contexte français - anglais

Each oscillator (31) has two outputs (35, 60), one (60) of which is an open collector point.

Similarly, pulse direction and the output driver – either Push-Pull (HTL) or RS422 (TTL) – can be defined through software parameters.

Similarly, pulse direction and the output driver – either Push-Pull (HTL), RS422 (TTL) or Open Collector (NPN) – are defined through software.

The small grey box on the leftmost picture contains a 7805 and a 76ls06 to driver the opto couplers.

A general open-collector interface is shown below:

Each oscillator (31) has two outputs (35, 60), one (60) of which is an open collector point.

An “open-collector” interface has two possible state: low, or high impedance.

An "open-collector" interface has two possible state: low, or high impedance.

The bus is “idle” when both lines are high (open-collector).

The bus is "idle" when both lines are high (open-collector).

The Data and Clock lines are both open-collector with pullup resistors to Vcc.

Next Post:Devil May Cry 5 North American Collector’s Edition Revealed

Devil May Cry 5 North American Collector’s Edition Revealed

A collector's box would have nothing without its plethora of collectible bonus.

The COLLECTOR (1965) dir William Wyler, with Terence Stamp